Extreme Networks x-605, Инструкция по эксплуатации

Страница: 21 / 36

INC INC DEC DEC
- -
+ +
Start
Enter
Start
Enter
Batt type
Stop
Current
voltage
battery
Suppiled
capacity
Charge
current
Charging
time
Number
of
cells
The value on the left side of the second lines sets the charge
current. The value on the right side of the second lines sets the
battery pack's voltage. After setting current and voltage, press
STAR/ENTER for more than 3 seconds to start the process.
This displays the number of cells you set up and the
processor detects. R shows the number of cells detected
by the charger and S is the number of cells set by you at
the previous screen. If both numbers are identical you
can start charging by press START/ENTER button. If not,
press BATT TYPE/STOP button to go back to previous screen
to carefully check the number of cells of the battery
pack before going ahead.
This screen shows the real-time status during charge process.
Press BATT TYPE/STOP key once to stop the charge process.
FAST CHARGING OF LITHIUM BATTERY
19
Fast charging of lithium battery
Charging lithium battery in the fast charge mode
Charging current will become lower when it progress to the end of charging. A specific CV process
will be reduced to end the charging process earlier. In fact, the charging current will goes to 1/5
when the charging process comes to 1/10.
Charging capacity will be little smaller than normal charging, but charging time will be shortened
accordingly.
‘>3 second’