Extreme Networks x-605, Инструкция по эксплуатации

Страница: 18 / 36

The program is only suitable for charging/discharging Lithium(LiPo/LiIo/LiFe) batteries with a
nominal voltage of 3.3/3.6/3.7V/cell. Different batteries have different charge technique. There
are two methods termed as constant voltage and constant current. The charge current varies
according to battery capacity and specification. The final voltage is very important; it should
precisely match the voltage of the battery: LiPo is 4.2V, LiIo is 4.1V and LiFe is 3.6V. The current
and voltage of the battery should be correctly set.
When you want to change the values of parameters, please press START/ENTER key to make it
blink and then use DEC or INC to change the value. Then press START/ENTER key again to
store the value.
Lithium (LiPo/Lilo/LiFe) program
16
INC
INC
INC INC
DE C
DE C
DE C DE C
-
-
+
+
INC
INC
DE C
DE C
- +
The program provides maximum capacity protection function. If the Delta-
peak voltage can not be detected or the safety timer times out, the charge
process will stop automatically, when the battery reaches the user-set
maximum charge capacity,
The beep to confirm users' operation sounds every time a button is pressed.
The beep or melody sounds at various times during operation to confirm
different mode change. These functions can be switched on or off.
This function monitors the voltage of the input battery used to power this
charger. If the voltage is lower than user-set value, the program will end
forcibly to protect the input battery.
INITIAL PARAMETER SETUP (USERS SET UP)