5. Insert the Ethernet connector to the main access point body and into the connector until the locking
tab clicks into place.
Note
Ensure that the small tabs on the claw fit into their counterparts on the main body.
6. Insert the seal and the claw into the main body.
7. Screw the sealing nut onto the threaded main body.
8. Tighten it to a torque of 12 in-lbs.
9. Connect the other end of the Ethernet cable to a PoE injector or a PoE-enabled switch.
Install the Waterproof Ethernet Cable Housing
26
ExtremeWireless™ AP460C, AP460S6C, and AP460S12C Access Points
