Extreme Networks Altitude 4600 Series, Руководство по установке, Страница: 19 / 47

Altitude 4600 Series Access Point Installation Guide
19
NOTE
When pre-drilling a hole the recommended hole size is 2.8mm (0.11in.) if the screws are
going directly into the wall and 6mm (0.23in.) if the provided wall anchors are being used.
4 If required, loop a safety wire, between 1.5mm (.06in.) and 2.5mm (.10in.) in
diameter, around the tie post and secure the loop.
5 If required, install and attach a security cable to the unit’s lock port.
6 Place the large corner of each of the case’s mount slots over the screw heads.
7 Slide the case down along the mounting surface to hang the mount slots on the
screw heads.
8
Attach appropriate antennas to the connectors.
9 Attach the Ethernet cable to the unit and to a switch with an 802.3af compatible
power source.
10 Verify the unit has power by observing that the LEDs are lit or flashing.
External Antenna Suspended Ceiling Tile (Plenum)
Mount Instructions
Ceiling mount requires placing an Altitude 4600 Series Access Point above a suspended
ceiling and installing the provided light pipe for viewing the status lights of the unit.
NOTE
Notes or warnings about suspended ceiling mounts apply to all installations where the unit is
placed on suspended ceiling tile. The case has a safety wire tie point for a standard safety wire.
CAUTION
Extreme Networks does not recommend mounting an Altitude 4600 Series Access Point directly to
a suspended ceiling tile with a thickness less than 12.7mm (0.5in.) or a suspended ceiling tile
with an unsupported span greater than 660mm (26in.). Extreme Networks strongly recommends
fitting the access point with a safety wire suitable for the specific installation. The safety wire
should be a standard ceiling suspension cable or equivalent steel wire between 1.59mm (.062in.)
and 2.5mm (.10in.) in diameter.