background image

5

If you have any questions regarding this product and its safe use, or if there are any missing or damaged parts, DO NOT return Boat Lift Boss

 to the retailer. 

Call the Boat Lift Boss

 Service Department at: 651-357-1874 or e-mail - [email protected]

Boat Lift Boss Installation Guide 

for Harbor Master

PART #: 3005.7243

Extreme Max™ Boat Lift Boss™ Direct Drive Systems are conditionally warranted for consumer use for 2 years after the date 
of retail purchase. Warranty valid only in the USA and Canada. 

Extreme Max™ Boat Lift Boss Direct Drive Systems are conditionally warranted to the original retail purchaser to be free from 
defects in material and workmanship, ordinary wear and tear expected. This warranty shall not apply to any defects caused 
by (I) overloading, (II) physical abuse of goods or any acts of vandalism by any person, (III) improper installation or use  
contrary to the instructions, (IV) commercial use, (V) saltwater use. The sole remedy under this warranty is at the  
discretion of the manufacturer: the repair of the product by the manufacturer at the manufacturer’s facility, or the  
replacement of the same or similar product. Extreme Max™ is not responsible for any consequential or incidental damages. 
The consumer shall be responsible for shipping charges to return any unit believed to be defective to Extreme Max™.  
Repaired or replacement units shall be returned to the consumer at the manufacturer’s expense. In the event that a unit is 
not defective, it will be returned to the consumer at the consumer’s expense. Any and all expedited freight charges to handle 
warranty claims are the responsibility of the consumer. Extreme Max™ is not responsible for any 3rd party labor charges that 
may be incurred in removing, transporting or installing the lift.

Extreme Max™ disclaims any other express warranties, all UCC implied warranties, and warranties of merchantability and 
fitness for purpose. 

To expedite warranty service, please complete and return the Warranty Registration Card along with a copy of original retail 
sales receipt at the time of purchase.  

To submit a warranty claim, please send your name, mailing address, original sales receipt and summary of alleged defect to 
[email protected]. Please e-mail or call (651) 357-1874 with questions regarding warranty service and claims.

LIMITED WARRANTY

If there are any missing or damaged parts,  

DO NOT return Boat Lift Boss™ to the retailer. 

Call the Boat Lift Boss

 Service Dept. at: 651-357-1874 

E-mail - [email protected]

24 VOLT DIAGRAM

Using 24-volt power can nearly double your pulling speed. Wire the batteries in series according to the  
following instructions and diagram.

WARNING:

 

 

Electric arc flash hazard. Improperly connected terminals may result in explosion or electric shock. 
Follow all instructions for wiring in series. Always connect to positive (+) terminal before negative (-) 
terminal.

1) Attach the jumper wire to the positive (+)  terminal of one battery, then the negative (-) terminal of the other. 
2) Attach the solar panel’s positive (+) power lead to the remaining positive (+) battery terminal.
3) Attach the solar panel’s negative (-) power lead to the remaining negative battery terminal.

12 Volt Battery

12 Volt Battery

24V Solar Panel

Red/White Wire

Black Wire

Jumper Wire

White or red wire: Po
Black wire: Negative -

Содержание Boat Lift Boss






Отзывы: