Extreme Flight YAK-54 ARF, Инструкция по эксплуатации

Страница: 13 / 50

13. Thread 2 of the heavy duty ball links onto one of the 2 longer of the
titanium pushrods. Remember that the ends of the pushrods are
reverse threaded so that they can be adjusted like a turnbuckle without
removing the linkage. Insert a 3mm socket head cap screw into the
ball link and into the servo arm. If using the SWB arms you will
need to drill out the hole to accept the 3mm bolt. Secure with a 3mm
nylon insert locknut.
14. Place the servo arm onto the servo (which you should have
electronically centered in a previous step) and make sure the elevator
is in the neutral position. Adjust the ball links until the linkage fits
between the composite control horns and lines up with the pre-drilled
top hole. Insert a 3mm socket cap screw, through one side of the
composite control horn, through the ball link, and finally through the
other composite control horn. Secure with a 3mm nylon insert lock
nut. Use blue Loctite on all bolts! Below is the finished set-up.
13