18.
Place an ez-connector on the servo arm. Locate the elevator pushrod and thread a ball
link onto the pushrod. Electronically center the servo. Use the 2mm bolt and nut to
connect the ball link end of the pushrod to the elevator control horn. Tighten the set
screw in the ez connector to clamp down on the pushrod, while making sure the
elevator is in the neutral position.
Make sure to file a flat spot on the pushrod to
allow the set screw to seat properly and maintain a firm grip on the pushrod wire
.
IT IS IMPERATIVE THAT YOU USE A METAL GEAR SERVO FOR THE
ELEVATOR!!!!!!
We highly recommend the Hitec HS-65MG. If you plan to fly
precision aerobatics only, I recommend using the short servo arm to allow for
maximum servo resolution and a very positive and accurate elevator actuation.
