19. Thread 2 of the heavy duty ball links onto one of the 2 longer titanium pushrods.
Remember that the ends of the pushrods are reverse-threaded so that they can be
adjusted like a turnbuckle without removing the linkage.
20. As shown in the picture below, secure one end of the ball link to the servo arm
using a 3mm socket head cap screw, washer and nylon insert locknut. If using the
SWB arms, you will need to drill out the hole to accept the 3mm bolt. Secure the
other end of the ball link to the control arm with a 3mm bolt, 2 washers, and
nylon insert locknut being careful not to over-tighten and damage the control
arms.
16
