59. Once you’re satisfied with the fit of the cowl, add some thick CA or Epoxy to the
intersection of the cowl and plywood cowl ring. Slide the cowl into position and secure
with 4 x 3mm bolts and washers through the pre-drilled holes in the cowl.
(2 per side)
60. Before installing the stab/elevators, remove the covering in rear sides of the fuse to
expose the pre-mounted 3mm blind nuts. You will also need to open a hole for the
servo leads to pass through.
61. Attach 36 inch servo extensions to each elevator servo. If you plan to remove the
stabs for transport, you will need 48 inch extensions. Slide the stab halves onto the
carbon fiber stab tube and secure with a 3mm bolt and washer inserted through the
39
