Extreme Flight Legacy Aviation Muscle Bipe, Инструкция по сборке

Страница: 29 / 29

Recommended throws:
Ailerons Elevator Rudder
Low: 5/8” or 15 degrees/20% expo…3/4” or 15 degrees/20% expo...2” left & right/25% expo
Med.: 1 1/4” or 25 degrees/30% expo…1 1/4” or 23 degrees/30% expo…2.5” Lt/Rt./35% expo
High: 1 3/4” or 37 degrees/40% expo…1 3/4” or 30 degrees/40% expo...3” Lt/Rt, 40-45% expo
Note: the throws are measured by an angle finder or holding a ruler to the outer most
portion/where the chord is the widest of the control surface. Be advised the high rates will make
the Muscle Bipe extremely responsive and is only recommended for expert fliers.
Gyro: we used the Aura 8 flight control system. There are various ways to setup a gyro, we will
look at our setup. First go to
www.flexinnovations.com and refer to their instructions regarding
the Aura 8 FCS. We chose to run a separate receiver and setup up the gyro using the downloaded
software. This allows you to make all adjustments thru a computer directly into the Aura 8.
Flying the Muscle Bipe: this is not a dedicated 3D plane and as such excels at sport flying and
classic aerobatic maneuvers. You will find with a proper setup the Muscle Bipe is a very mild
mannered airplane and is capable of loops/rolls/spins/knife edge flight and various derivatives of
those base maneuvers. Takeoffs should be made by slowly advancing the throttle and guiding it
with the rudder, it will likely become airborne before full throttle is achieved and this is normal.
Landings are made by establishing a constant glide path and just before touch down slowly
retard the throttle and touching down.
Thanks again for your purchase of the Legacy Aviation Muscle Bipe!
Jeff Williams
Team Extreme