6. Use the screws provided by the servo manufacturer to secure the aileron
servo in the designated location. 1 screw installed in the center hole at each
end of the servo is adequate to secure the servo. Make sure the output shaft is
positioned toward the trailing edge of the wing.
7. Locate the 2 threaded pushrods that are the same size and 4 micro ball
links along with 4 2mm screws, nuts and washers. Thread the ball links onto
each end of the pushrods and secure to the servo arm and control horn with
the 2 mm hardware as shown in the picture. Use the longest arm provided
with your servo.
Repeat this process for the other wing half.
8
