Extreme Flight ARF RC, Инструкция по сборке

Страница: 11 / 16

Install the rudder servo and center the double servo arm. Assemble the ball links and the pull-wire ends as
shown. Thread the pull-wire end in the ball links four to five turns. This will allow room to tighten the wires
after pull-pull wire installation is complete. Start at the rudder servo first. Thread the crimp sleeve on the wire
first, then through the pull-wire end. Back through the crimp sleeve. Allow enough wire through the sleeve to
loop back through the sleeve a third time. Once satisfied with the wire position, crimp the sleeve with a
needle-nose pliers. After the wires are attached to the rudder servo, tape the rudder in the neutral position.
Use the same technique to attach the pull-pull wires to the rudder. Take as much slack out of the wires as
possible before crimping the sleeves. Screw the pull-wire ends in to the ball links to take up the remainder of
the slack. Note: you want the pull-pull wires to be taught but not "banjo string" tight. They should not sag at
neutral position. After a few flights, recheck.