2
Standard Package
1x Protective Cover
1x Fabric Canopy Roof *
1x Instant Canopy Frame
4x Tie Down Straps
4x Steel Pins
Please note your accessories are not listed here, instructions do follow.
WARNING READ INSTRUCTIONS CAREFULLY BEFORE USE
4. Connect the velcro on roof corners to the
velcro on the corners of the frame legs.
8. Lift all four roof connectors until pin locks
into position. Stand on foot plate and lift with
two hands, you will hear a ‘Click’.
7. Ensure there are not trip hazards. Walk
backwards and open frame fully.
11. Extend back legs, repeat step 10.
Once Canopy if is set-up
REFER TO
SECURING YOUR CANOPY ON PAGE 3.
2. Holding the lower side of the truss bars (as
shown) open frame 75% of full extension.
1. Remove all your items from packaging and
clear a safe area.
5. Fit the peak of the roof to the center pole/s
of the canopy, tighten the toggle.
9. Ensure protective flap is over the truss
connector, this will protective roof from wear.
Attach roof straps by looping straps around
frame and engaging clip. Tighten the strap.
3. Fit the roof to the frame.
6. Grasp Canopy truss bars (as shown).
10. Extend front Canopy legs. Using one
foot stand on the foot plate, release the
button on the middle leg connector and
extend front legs to desired height.
10’ X 20’ CANOPY SETUP
REFER TO PAGE 3 >>
SET- UP INSTRUCTIONS
Please read instructions completely before setting up your canopy. Make sure you have all the parts identified on the Parts List.