Extrema Machinery XS-1A25, Руководство пользователя

Страница: 15 / 27

GREASING & LUBRICATION
1. Check all oil and grease nipples weekly.
2. Check oil tank level monthly.
3. Check the gearbox yearly.
4. Lubricate the shaft and the bushing of the tension unit regularly.
5. First month only:
•
Drain out oil and change with new oil after the first month of operation. In running
period, change oil at 2500 hours or 6-month intervals, whichever comes first.
DISTURBANCES
Disturbances Possible Cause Solution
Fuses are blown Insert a new fuse
Not enough tension on
sanding belt Use turning switch to apply
tension to belt
Emergency stop button still
pressed in Press button again
Pressure is too low Check the air supply unit
Thermal relay switched off Press the button of the
thermal relay
The machine does not run
Sanding belt touching the belt
protection switch Push the belt backwards
Irregular air supply Check air supply unit and
remedy any disturbances
Water in the air unit Draw off the water
Overload of the sanding
aggregate Remove less material during
sanding
Machine repeatedly stops
Rattling of the sanding belt
against the forks of the auto
belt protection Check sanding belt and
replace if necessary. Adjust
belt protection somewhat
wider
Speed control valve is not
correctly adjusted To be re-adjusted Sanding belt runs off to one
side
Oscillation of the belt is not
correct To be re-adjusted
Slipping of the conveyor belt Contact roller is too high Lower the contact roller