Extrema Machinery XS-1A25, Руководство пользователя

Страница: 14 / 27

GENERAL MAINTENANCE OF THE CONVEYOR BELT
1. Tension of the Conveyor Belt:
A. The feeding conveyor has auto tracking by limit switch and air cylinder.
B. The conveyor belt can be adjusted, if it is too loose, with the socket wrench
provided.
C. We do not recommend tightening the conveyor belt, as this affects the life of the belt.
2. Re-conditioning of the Conveyor Belt:
This should be done if the surface of the belt is too smooth, so that the work piece is
slipping or if the surface of the belt shows irregularities.
A. Apply a sanding belt with 60 grit or coarser.
B. Put the table on the lowest position.
C. Put the front pressure roller on position 0.
D. Switch off the table floating (if on machine).
E. Switch on the main motor together with the feed motor.
F. The table is to be raised slowly.
G. The conveyor belt should be sanded off as little as possible. See to it that the whole
surface is touched.
H. Lower the table about 3mm, then switch off the main motor and feed motor.
NOTE: Sanding of the conveyor belt can be properly done if the contact drum is parallel
to the table and the pressure roller.
THIS SHOULD BE CHECKED FIRST
MAINTENANCE OF THE AIR UNIT
1. Daily Maintenance: Remove condensation water from air filter.
2. Monthly Maintenance:
A. Clean the inside of the plastic housing with a dry rag. Do not clean with detergent or
other liquid.
B. Remove brass filter unit and clean with acetone or petrol and air pistol.
3. Clean the electric eye with dry rag.