Extraflame Dorina, Руководство пользователя

Страница: 21 / 36

ENGLISH
user menu
pelleT feeD aDjusTmenT
The following menu allows to adjust the percentage of pellet feed.
if the stove has functioning problems owing to the quantity of pellets, adjust pellet feeding directly from the control board.
The problems correlated to the amount of fuel can be divided into 2 categories:
NO FUel:
Š
the stove can never develop a suitable flame, tending to remain very low even at high powers.
Š
at minimum power the stove tends to almost switch-off taking the stove into “NO pelleTs” alarm condition.
Š
when the stove displays the “NO pelleTs” alarm, there may be non-burned pellets inside the burn pot.
exCess FUel :
Š
the stove develops a very high flame even at low power.
Š
the panoramic glass is very dirty, obscuring it almost totally.
Š the burn pot tends to become encrusted, blocking the holes for air intake due to the excessive pellet feed, as it is only
burned partially.
The adjustment to be performed is in percentage. Therefore changing this parameter will lead to a proportional variation of all
stove feeding speeds. Feeding is from -30% to +20%.
Follow the procedure on the display to perform the procedure:
J
clean check up 1 - 2
shoulD The alarm "clean check up" be TriGGereD, make sure ThaT The
boTTom of The burn poT is free from resiDues or scalinG.
The holes aT The boTTom musT be compleTely free To GuaranTee
correcT combusTion.
The aboVe inDicaTeD "pelleT feeD reGulaTion" funcTion can be useD
To aDjusT combusTion baseD on The DescribeD reQuiremenTs.
if The alarm persisTs anD The aboVe lisTeD conDiTions haVe been
checkeD, conTacT The QualifieD afTer-sales assisTance cenTre.
CONTrOls prOCeDUre
Š press key 5 for a few seconds, until seT ClOCK appears.
Š press key 3 several times to reach seT User.
Š
Confirm using key 5.
Š
pellet is displayed.
Š
via key 2 and 3 it is possible to increase(3) or decrease (2) feeding during the wOrK phase.
Š
press key 1 several times to confirm and exit the menu.
BUrN pOT BOTTOm
sTanD - by
The stby function is used if immediate stove switch-off is required when the set temperature has
been reached.
The sTBy function can be set at ON or OFF using the procedure described further on.
in the factory the sTby function is always set at off (indicator off)
21