20
COMFORT PLUS INSTALLATION
Chapter 4
The air vent must be made outside the fl ue as it must not suck heated air.
Fix the base using the locking screws. Connect the conveyor pipe correctly to the piping for fl ue evacuation,
the air vent box to the relative intake pipe and the conveyor to the ducting piping.
Re-position the machine body by repeating the operations carried out previously in the reverse order.
Finally, use the Allen wrench to turn the lockbolt anti-clockwise to block movement.
To understand whether the insert is correctly attached to the base, connect the plug to the socket: the
display should switch on. Mount the hopper support for the pellet and insert it into the relevant coupling.
Adjust the height and the inclination of the hopper on the basis of the fl ue that will be built
ATTENTION!!!
If our pedestal is used, a slot must be created in the fl ue that allows to check the pellet
level in the feed-box, thus preventing escape during fi lling.
The hopper support can be mounted in both sides of the insert.
The lower grill of the insert must lie at least 1 cm above the fi re surface in covering
marble.
INSERT EXTRACTION
The extraction of the Comfort Plus allows to load
pellets inside the feed-box and to perform routine
maintenance, (cleaning the ash pipe at the end of the
year) or extraordinary maintenance (replacement of
mechanical parts if the product should break).
Maintenance operations must be
performed when the insert is off , with
the plug disconnected from the socket
and by an authorised technician.
Follow this procedure to extract the insert:
Take the relevant Allen wrench and insert it
into the screw positioned in the bottom left.
Turn the wrench anti-clockwise.
Using the relevant fi re irons, pull the machine
towards yourself until it blocks automatically.
MOUNTING THE FRAMES
Front frame
Side frames
Fix the lateral frames using 2 self-threading screws
per side, which are supplied: the right and left sides
are already perforated for fi xing the 2 frames.
Any wooden beams situated above
the insert must be protected with
non-infl
ammable material. Frame
assembly is important as it allows
correct recirculation of the air and
consequently optimal product
functioning.
fi gure 4.5
Содержание Comfort Plus
