Extraflame ANGELA, Руководство пользователя

Страница: 20 / 36

ENGLISH
FrOnt aIr
From the menu, it is possible to adjust the speed (-2, -1, 0, +1, +2) of the front fan.
To adjust the speed : oK > froNT aIr > SpeeD
dUctInG
From the menu, it is possible to enable/disable and adjust
the ducting speed (-2, -1, 0, +1, +2).
To enable : oK > DUcTINg > eNaBLe
To adjust the speed : oK > DUcTINg > SpeeD
easy setUp
The volumetric pellet weight is the ratio between the pellet weight and pellet volume. This ratio
may change without altering pellet quality. By using the EASY SETUP function, it is possible to
change the calibration of the volumetric weight by increasing or decreasing the preset values.
In the stove program, the available values go from “– 3” to “+ 3”; all stoves are calibrated in production
with the optimal value, which is 0
If you notice an excessive deposit in the burn pot, access the
EASY SETUP
program and lower the value by one unit to “- 1”; then wait
until the next day and if there is no improvement, decrease again, to a maximum of “- 3”. If on the other hand the volumetric pellet weight
calibration needs to be increased, change the value from the factory setting of “0” to “+1, +2, +3” as required.
To set: oK >
EASY SETUP
EXCESSIVE PELLET DEPOSIT IN BURN POT
NORMAL
fUNCTIONINg
LOW PELLET DEPOSIT IN BURN POT
-3 -2 -1 0 +1 +2 +3
ThIrd decreASe
rAnge IF The
FIrST TWo Are
InSuFFIcIenT
Second
decreASe
rAnge IF
The FIrST IS
InSuFFIcIenT
FIrST decreASe
rAnge (TeST For
1 dAy)
opTIMAl FAcTory
VAlue
FIrST IncreASe
rAnge
Second
IncreASe rAnge
IF The FIrST IS
InSuFFIcIenT
ThIrd IncreASe
rAnge IF The
FIrST TWo Are
InSuFFIcIenT
N.B.: If this calibration does not rectify the pellet deposit level in the burn pot, contact your local after-sales service centre.
20