RC200-EU-EN-V1.5-4/12
2
Introduction
Congratulations on your purchase of the Extech RC200 RC Tweezers Multimeter This meter, using the
tweezers adaptor, measures SMD capacitors, resistors, diodes and continuity test. With the test lead
adaptor, it measures AC/DC Voltage. Proper use and care of this meter will provide many years of
reliable service.
Safety
INTERNATIONAL ELECTRICAL SYMBOLS
Caution ! Refer to the explanation in this Manual
Caution ! Risk of electric shock
Earth
(Ground)
Double Insulation or Reinforced insulation
This meter has been designed for safe use, but must be operated with caution. The rules listed
below must be carefully followed for safe operation.
1.
NEVER
measure voltage with the Tweezer adaptor installed.
2.
NEVER
apply voltage or current to the meter that exceeds the specified maximum:
Input Protection Limits
Function Maximum
Input
V DC or V AC
600V DC/AC
3.
USE EXTREME CAUTION
when working with voltages greater than 25VAC or 35VDC. These
voltages are considered a shock hazard.
4.
DO NOT
measure voltage if the voltage on the "COM" input jack exceeds 600V above earth
ground.
5.
NEVER
connect the meter leads across a voltage source while the function switch is in the
capacitance, resistance, or diode mode. Doing so can damage the meter.
6.
ALWAYS
discharge filter capacitors in power supplies and disconnect the power when making
capacitance, resistance, continuity or diode tests.
7.
ALWAYS
turn off the power and disconnect the test leads from the circuit before opening the
cover to replace the batteries.
8.
NEVER
operate the meter unless the battery cover is in place and fastened securely.
9.
NEVER
operate the meter if any part is damaged.
10.
ALWAYS
turn the meter off when not in use.
!
