Model 401036 Version 3.1 9/07
5
Sampling Rate
The sampling rate is the interval of time between logged readings. Note that there are
two
sampling rate selections for two separate datalogging scenarios described below:
1. PC Sampling Rate
The PC sampling rate is the rate at which measurements are recorded by the PC
while the meter is connected to the PC
. This is known as real-time recording since
the readings are being taken by the meter and recorded by the PC at the same
time. Set the rate in the supplied software program as described in the PC
SAMPLING paragraph on page 6.
2. Datalogger Sampling Rate
This is the meter’s internal sampling rate used when the meter is logging readings
remotely in continuous recording mode (disconnected from the PC). The default
rate is 1 second. Change the rate in software by following the steps on page 6 for
SAMPLING TIME with the meter connected to the PC.
PC Interface
Connect the supplied interface cable to the phono jack on the right side of the light meter
and to the PC 9-pin COM port.
Windows
TM
Software
Refer to separate instructions supplied on the Software Program disk for the operation of
the Windows
TM
Software.
