INSTALLATION
The installation procedures have two sections for each type of interface.
1. PCMCIA interface
2. Parallel Port interface
The procedure includes hardware and software installation. Just follow along the interface of your
choice.
INSTALLATION FOR PC CARD INTERFACE
HARDWARE INSTALLATION
If install on a NT station, make sure you turn OFF all power to your system before connecting the
HD Traveler Plus to your computer. However, you are allowed to install the HD with power while
using Windows 95/98, because the OS supports plug-and-play.
1.
Connect the PCMCIA interface card to the HD drive. Push firmly
until the HARD DISK connector is seated, and then tighten the two
screws on the cable connector.
2.
Place the HD drive in the horizontal position.
3.
Consult your computer’s documentation to locate the PCMCIA
slot.
4.
Align the PCMCIA interface card with the arrow sign pointing to
the computer’s slot. (Please note that the card is keyed to guide
for proper orientation.)
5.
Slowly insert the PCMCIA interface card into the slot and press
firmly until the card is seated.
6.
You are now ready to install the HD Ttaveler Plus device driver.
CAUTION
The hard disk and electronic components installed on the Hard disk Traveler
Plus are very sensitive to damage from static electricity. Before handling the
unit, touch a grounded metal surface. DO NOT connect/disconnect the HARD
DISK PCMCIA interface connector to/from the PCMCIA interface card when
the system is in power-on state.
