INSTALLATION FOR PARALLEL PORT INTERFACE
HARDWARE INSTALLATION
Before you begin, make sure you turn OFF all power to your system before connecting the HD
TRAVELER to your computer.
1. Connect the DC Input adapter cable to the EXP Hard Disk Traveler drive assembly.
2. Connect one end of the Parallel cable to EXP Hard Disk (25 pin connector), and connect the
other end to computer parallel port.
3. Plug-in the AC adapter to a working AC receptacle.
Note: The EXP hard disk will start to spin up immediately. Be careful, do not move the EXP
hard disk while it is spinning.
CAUTION
The hard disk and electronic components installed on the Hard disk Traveler
Plus are very sensitive to damage from static electricity. Before handling the
unit, touch a grounded metal surface. DO NOT connect/disconnect the HARD
DISK PCMCIA interface connector to/from the PCMCIA interface card when
the system is in power-on state.
