g204645
Figure 18
1.
New hole location
2.
Measure for new hole location
3.
Measure for cut line
4.
Cut tube
B.
Drill three 3/8 inch holes.
C.
Measure from the end of the tube the amount to
remove, create marks, and apply masking tape
around the tube as a guide.
D.
Carefully cut the tube and discard the end.
6.
Drill the 7/32 inch holes in the lower tube using the
upper tube holes as reference. See Figure 19.
7.
Remove tubes from the unit and assemble the upper
and the lower tubes using three #10-24 x 3/4 inch
hex washer head screws, three #10 washers, and
three #10-24 nyloc nuts. The screw head should
be installed to the inside of the tube to provide
minimum obstruction to flow. Make sure that the
upper and the lower ends are oriented properly as the
tubes are assembled. (Parting lines should roughly
be lined up.)
g007028
Figure 19
1.
Drill the holes here
Installing the ROPS Pin
To prevent the ROPS bar from damaging the hopper,
install the ROPS pin assembly.
1.
Using 11/64 or #19 drill bit, drill the inner RH ROPS
hole 3/4 inch (19mm) deep as shown in Figure 20.
g038069
Figure 20
1.
Drill
3.
#10-24 x 3/4 inch hex
screw
2.
#10 washer
4.
ROPS pin with lanyard
2.
Place the #10 washer and lanyard cable end onto
the #10-24 x 3/4 inch hex screw and install into the
RH ROPS hole.
3.
Install the ROPS pin.
4.
Repeat steps 1 through 3 for the LH ROPS.
Fill Out Warranty Registration
Form
Fill out the online warranty registration form.
9
