Exmark Laser Z XS, Руководство оператора

Страница: 42 / 56

37
4.2.4 Mule Drive Belt Tension Adjustment.
Self-tensioning idler, adjust as follows:
a) Stop engine, wait for all moving parts to stop, and remove key. Engage
parking brake.
b) Check to make sure the center of the bolt head in the center of the spring
loaded pulley, on left side engine deck support, is positioned between the
centers of the two alignment holes in the left support plate (See Figure 9). It
is necessary to adjust the belt tension when the center of the bolt head is at
or below the center of the bottom alignment hole.
c) When adjustment is necessary, loosen the idler pulley on the right-hand
side so it can move up and down in the slot.
Place a wrench on the 3/8” nut in the center of the spring loaded pulley and
apply upward pressure to relieve tension on the spring (a 1/2” drive breaker
bar and 9/16 socket works best).
Reposition the adjusting pulley to the bottom of the slot.
NOTE: When installing a new belt, it is necessary to reposition the right
adjusting pulley upward in the slot in order to position the center of the
spring loaded pulley between the alignment holes.
4.2.5 Deck Belt Tension.
a) The deck belt is tensioned by a self-tensioning idler, no adjustment is
necessary .
4.2.6 Alternator Belt Tension.
a) Stop engine, wait for all moving parts to stop and remove key. Engage
parking brake.
b) Tilt seat and remove air deflector panel.
c) To tighten alternator belt, loosen both upper and lower alternator mounting
bolts. Rotate alternator out, away from engine and re-tighten hardware to
secure in place.
d) When properly tensioned, the alternator belt will deflect 1/4”-3/8” (7-9mm)
while applying 22 pounds of force to the belt midway between fan and
alternator.
4.2.7 Belt Guide Adjustment.
a) Stop engine, wait for all moving parts to stop, and remove key. Engage
parking brake.
b) Remove the belt shield on the right side of mower deck.
c) Note belt guide bolted to deck near the shield support stud and right-hand
pulley. Guide should be 1/8” (3.2 mm) away from the belt, with bolt-end of
guide near end of slot (See Figure 10).
d) If adjustment is necessary, loosen the bolt securing the belt guide and
make proper adjustment. Tighten hardware.
FIGURE 9
For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com