35
NOTE: When changing cutting height positions, always come to a
complete stop and disengage the PTO.
FIGURE 6
d)
Insert height adjustment pin into hole corresponding to desired cutting
height and install hairpin cotter. See decal on the side of deck lift plate.
e)
Move lever out of transport (or 5” (12.7 cm) cutting height) position and
down onto height
adjustment
pin
to
mow
at
selected height.
f)
To transport, move lever back up to transport (or 5” (12.7 cm) cutting
height) position.
Note: The foot operated deck lift assist lever can be used to momentarily
lift the deck to clear objects. Be sure that PTO is disengaged.
g)
Adjust anti-scalp rollers for Normal Operating Conditions. Place rollers in one
of the positions shown in Figure 10. Rollers will maintain 3/4 in. (19 mm)
clearance to the ground to minimize gouging and roller wear or damage.
For Maximum Deck Flotation,
place rollers one hole position lower.
Rollers should maintain 1/4 in. (6.4 mm) clearance to ground.
DO NOT
adjust rollers to support the deck. Be sure roller bolts and nuts are
installed with the spring disc washer between head of the bolt and
mounting bracket. Torque the 3/8-24x2 Gr 8 hex capscrew to 50-55 ft-lbs
(68-75 N-m)
FIGURE 7
4.2.2 Deck
Leveling.
a)
Position mower on a flat surface.
b)
Stop engine, wait for all moving parts to stop, and remove key. Engage
parking brake.
c)
Check tire pressure in drive tires. Proper inflation pressure for tires is 10 psi
(90 kPa). Adjust if necessary.
For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
Содержание Laser Z XS
Страница 50: ...45 7 ELECTRICAL DIAGRAM For Exmark Mower Parts Call 606 678 9623 or 606 561 4983 www mymowerparts com ...
Страница 51: ...46 8 HYDRAULIC DIAGRAM For Exmark Mower Parts Call 606 678 9623 or 606 561 4983 www mymowerparts com ...
Страница 53: ...48 NOTES For Exmark Mower Parts Call 606 678 9623 or 606 561 4983 www mymowerparts com ...
Страница 55: ...50 For Exmark Mower Parts Call 606 678 9623 or 606 561 4983 www mymowerparts com ...
