11
11
Can be used powered directly via mains if battery not
charged.
1. Insert jack on end of cable (1) into socket on bottom
of trimmer.
2. Place adapter (1) in mains socket.
3. Proceed as described above.
NB! If the trimmer does not work when connected to
mains and battery is flat, switch off and recharge for
5 minutes. It will then work powered via the mains.
Battery charging
1. Insert jack on end of cable into socket on base of
trimmer or behind black part of base (2).
2. Plug in to mains.
3. Check trimmer is switched off (set on/off button to
0).
o Red LED (7) will be lit during recharging.
o Battery indicator (8) consists of 5 green LEDs
indicating battery capacity at 20, 40, 60, 80 and
100% respectively during charging and use.
Battery capacity during charging will be indicated
by a blinking LED. When 100% battery capacity is
attained, all 5 LEDs will be constantly lit.
o When charging is complete, the charging indicator
will blink for 5 minutes to indicate full charge.
Battery indicator will remain lit until appliance is
removed from base or cable is detached.
o Battery will begin to charge when appliance is
returned to base and base is connected to mains.
To avoid charging, disconnect adapter from mains.
o When battery is flat, charge indicator will blink to
indicate recharging is necessary.
o When battery is fully charged, the trimmer can
operate for approx. 45 minutes.
NB! For maximum operating time, recharge when
performance becomes noticeably reduced.
Tips
• Check the required comb attachment is fitted and
set to required length.
• Hold trimmer with flat side of comb attachment to
head, and move in slow, even movements through
the hair.
• Start with sides or neck. Work towards centre of
head. Trim fringe by moving trimmer from forehead
towards centre of head.
• If hair is longer than 40 mm, best results can be
achieved using the hairdresser’s comb (12 or 13)
or by holding the hair between your fingers while
trimming. Supplement with hairdresser’s scissors if
necessary (11).
• Brush hair cuttings regularly away from head to see
progress.
• Shake hair regularly from trimmer.
CLEANING AND MAINTENANCE
• Brush cutting head and comb attachments using
the small cleaning brush (15) after each use.
Remove cutting head if necessary:
o Check trimmer is switched off.
o Grip cutting head front edge, pull backwards.
o Brush recess under cutting head.
o Replace cutting head by inserting black tongue on
back of head into hole in trimmer, and push until you
hear a click.
• Lubricate as required: Place 1-2 drops on cutter and
run trimmer for approx. 10 seconds. Remove any
excess oil.
• Clean outside of trimmer using a damp cloth. Do not
use detergents of any kind.
INFORMATION ON DISPOSAL AND RECYCLING OF
THIS PRODUCT
Please note that this Adexi product is marked with this
symbol:
This means that this product must not be disposed of
together with ordinary household waste, as electrical
and electronic waste must be disposed of separately.
In accordance with the WEEE directive, every member
state must ensure correct collection, recovery, handling
and recycling of electrical and electronic waste. Private
households in the EU can take used equipment to
special recycling stations free of charge. In some
member states you can, in certain cases, return
the used equipment to the retailer from whom you
purchased it, if you are purchasing new equipment.
Contact your retailer, distributor or the municipal
authorities for further information on what you should
do with electrical and electronic waste.
Removing battery
1. Run battery until completely discharged.
2. Remove cutting head.
3. Remove screws on back of trimmer and separate
the two halves.
4. Remove printed circuit board.
5. Cut wire between PCB and battery. Remove battery.
GUARANTEE TERMS
The guarantee does not apply:
• if the above instructions are not followed
• if the appliance has been interfered with
• if the appliance has been mishandled, subjected to
rough treatment, or has suffered any other form of
damage
Due to the constant development of our products in
terms of function and design, we reserve the right to
make changes to the product without prior warning.
IMPORTER
Adexi Group
We cannot be held responsible for any printing errors.
