6
En
gl
is
h
Playback from an external device via Bluetooth
1. Switch the speaker on by holding down [
] until the charge/battery status
indicators come on and the Bluetooth indicator begins flashing rapidly.
2. Activate Bluetooth on the device to be paired with the speaker.
3. The speaker will appear on your device as
BTS-200
, select it and pair it with
your device.
4. Once contact has been established, the Bluetooth indicator will begin flashing slowly.
The indicator remains lit during playback.
5. Start playback on your device. Set the desired volume levels both on the external
device and the speaker. Playback can be controlled directly from the speaker or
from your device.
6. If you wish to connect another Bluetooth device while the speaker is on, press and
hold in [
►
ll ] for 3 sec. The Bluetooth indicator (2) will begin flashing, meaning that
it is now detectable for other Bluetooth devices.
Note:
• If you are prompted to enter a PIN code on your device, you should enter
0000
(four zeroes). Certain devices may also require you to approve the connection.
• If you have connected a mobile phone to the speaker via Bluetooth and receive
a call (or make one) whilst you are listening to music, the music will be switched off
automatically. Once the call ends, music playback will automatically be resumed
(if your phone settings supports this).
Playback from an external device via AUX
1. Switch the speaker on by holding down [
] until the charge/battery status
indicators come on and the Bluetooth indicator begins flashing rapidly.
2. Press [ M ] until the green AUX indicator comes on.
3. Plug a 3.5 mm audio cable into the AUX IN socket (11) on the speaker and
connect the other end to your device.
4. Start playback on your device.
5. Adjust the volume level on the connected device and the speaker.
6. Other playback settings can be controlled from the external device.
Note:
You cannot change tracks on the speaker when an external device is connected
via the AUX socket.
Charging external devices
1. Plug the device’s charger cable into the speaker’s USB charge port (10) and
your device.
2. Turn on the speaker and your device will begin charging.
3. Remove the device’s charger cable and turn off the radio once you are finished.
