Exhausto VEX5000 Series, Инструкция по сборке, установке и техническому обслуживанию

Страница: 15 / 64

3005831-2019-04-01.fm
Mechanical assembly
15/64
3.2.2 Fitting of roof
1. Seal between the sections.
2. Stick the sealing strips on the top of the air handling unit on all of the outsides (A).
3. Lay the U profile along (in the middle) the air handling unit as a roof ridge, to
achieve a fall toward the sides. Trim the U profile so that it ends a couple of
centimetres inside the air handling unit (B).
4. Lay the first roofing panel in against the top section.
5. Lay the next roofing panels, except the last. Pop rivet the roofing panels together
(F).
6. Fit the end piece profile 560 mm from the outside of the second last roofing panel
(C).
7. Turn the last roofing panel into the end piece profile and place it in position. Secure
using pop rivets (D/E).
8. Push the assembly rails in over the plate joints. Close using plastic end (G/H).
9. Secure roof facing top section using the plate “Roof finish facing end”.
Seal the joint.
10.Screw self tapping screws using nylon washers in all of the prepared holes.
Air handling unit
with rotor
1. Fit the end piece in one end with approx. 2 cm of overhang.
2. Lay the U profile lengthwise, so that it ends a couple of centimetres inside the air
handling unit.
3. Lay the next roofing panel, except the last. Pop rivet the roofing panels together (F).
4. Fit the end piece profile 560 mm from the outside of the second last roofing panel
(C).
5. Turn the last roofing panel into the end piece profile and place it in position. Secure
using pop rivets (D/E).
6. Push the assembly rails in over the plate joints. Close using plastic end (G/H).
7. Screw self tapping screws using nylon washers in all of the prepared holes.
Air handling unit
with wide rotor
A B C D
E F G H