Step 2
Remove the Left and Right Nylon Nuts (84) & (86) from the Left and Right Pedal (7) & (8).
The Cranks, Pedals, Pedal Shafts, and the Pedal Straps are marked “R” for Right
and “L” for Left.
Insert the Left Pedal (7) into the threaded hole in the Left Crank (23). Turn the pedal shaft
by hand in a counter-clockwise direction until snug (See Fig AA-2).
Note: DO NOT turn the left pedal shaft in a clockwise direction; doing so will strip
the threads of the left pedal shaft.
Tighten the Left Pedal (7) with the 13-15 mm Wrench provided, and then tighten the Left
Nylon Nut (84) by turning it in a clockwise direction with the 19mm Wrench provided.
Insert the Right Pedal (8) into the Right Crank (24).Turn the pedal shaft by hand in a
clockwise direction until snug. Tighten the Right Pedal (8) with the 19mm Wrench provided,
and then tighten the Right Nylon Nut (86) by turning it counter clockwise with the 19mm
Wrench provided.
Warning:
This machine is not intended to be pedaled in reverse.
*See ADJUSTMENTS page 16 for instructions to install and adjust the pedal straps.
ASSEMBLY
10
Tools:
19mm Wrench
1PC
13-15mm Wrench
1PC
