MAINTENANCE
Cleaning
The bike can be cleaned with a soft clean damp cloth. Do not use abrasives or
solvents on the plastic parts.
Please wipe your perspiration off the bike after each use. Be careful not to get
excessive moisture on the computer display panel as this might cause an
electrical hazard or the electronics to fail.
Please keep the computer console and the bike, out of direct sunlight to prevent
screen damage.
Please inspect all assembly bolts, nuts, screws, and pedals on the machine for
proper tightness every week.
Storage
Store the bike in a clean and dry environment away from pets and children.
TROUBLE SHOOTING
PROBLEM:
There is no display on the computer console.
SOLUTION:
Remove the Console Cover (69) and verify that the wire that comes
from the computer console is properly connected to the wires that come from the
rear frame.
SOLUTION:
Check if the batteries are correctly positioned and the battery springs
are in proper contact with the batteries.
SOLUTION:
The batteries in the computer console may be dead. Replace the
dead batteries with new batteries.
PROBLEM:
There is no heart rate reading or the heart rate reading is erratic /
inconsistent.
SOLUTION:
Make sure that the wire connections for the hand pulse sensors are
secure.
SOLUTION:
To ensure the pulse readout is accurate, always hold on to the
handlebar grip sensors with two hands instead of just with one hand.
SOLUTION:
Avoid gripping the hand pulse sensors too tight. Try to maintain even
pressure while holding onto the hand pulse sensors.
PROBLEM:
The bike makes a squeaking noise when in use.
SOLUTION:
The bolts may be loose on the equipment. Please inspect all of the
nuts, bolts, screws and tighten any loose Hardware.
MAINTENANCE
&
TROUBLE
SHOOTING
18
