COMPUTER
OPERATION
Manual Process
Step 1:
AC power on:
Segments test for 2 seconds
(figure 1)
, the speed setting shows up after a long beep for 2 seconds
(figure 2)
. The
monitor display then switches to
CLOCK
setting in 1 second. To set "Hour", first press
MODE
to enter setting. Then,
follow same process to set up "Minute". The monitor display will quit set up mode in 6 seconds if no button is being
pressed. After setting up is done, the monitor will display training mode that is allowed to preset each function target.
(figure 3)
Step 2:
After training starts:
(1)
If the Safety key is installed, press the
START/STOP
button to start the treadmill.
(figure 4)
. The initial running
speed is 0.4 m/h, it can be changed by pressing the
UP
button with each increment (or decrement by the
DOWN
button) of 0.1 m/h until the maximum speed of 4 m/h. If the button is pressed down for 1.5 seconds, the
increment and decrement will be doubled, and stop when the button is released. While the running speed is
adjusted, it is not able to have a loop function.
(2)
In the
STOP
mode, press the
MODE
button to set up
TIME
(0:00~99:00),
DISTANCE
(0.00~99.90), and
CALORIES
(0~9990). The blinking function is for presetting
(figure 5)
. Press the
SET
button to set each target.
Press the
RESET
button to clear the function value to zero.
(3)
In the
STOP
mode, press down the
RESET
button for 2 seconds to make all function values
RESET
.
Figure 1
Figure 2
Figure 3
10
