31
Technical Specifications
w w w . t e c n a r e . c o m
T Series | rev.:1.1
TANIT
TANIT SUB SPECIFICATIONS
Application information is presented for guidance only. Exel Acoustics SL reserves the right to make any necessary changes to
the products and the published specifications. As part of the ongoing development program Exel Acoustics SL tries to maintain the
highest degree of product compatibility
ACOUSTICAL
Operating Frequency Range
35 Hz - 195 kHz ±4dB, measured on axys. 45Hz-120kHz Recommended operating frequency range.
Response depends on loading conditions and room acoustics
Axial Sensitivity
96 dB (1w/1m) @half-space
Calculated SPL
131 dB continuous/137 Peak
Nominal Dispersion
360º
Nominal impedance
8 ohm
COMPONENT
Low Frequency
2 x 12-inch cone drivers neodymium magnets, direct radiation, bass-reflex
Nominal impedance: 16Ω/loudspeaker
Voice coil size: 88 mm / 3.5-inch
Power Handling Capability: 900 W AES / 1800 W continuous / loudspeaker
Note:
Power Handling measured using AES Standards= 2 hours test made with continuous pink noise signal
(6 db crest factor) from the recommended xover point. Power on Continuous Program is defined as 3 dB
greater than the Nominal rating
AUDIO INPUT
Connectors
IN: 1 x NL4 SpeakON®
LINK: 1 x NL4 SpeakON®
OUT: Autoconnect at top
Wiring
Pin 1+/-: LF+/- (passive mode); Pin 2+/- :LF+/- (bi-amp mode)
PHYSICAL
Enclosure
16 mm birch plywood. Finished in Polyurea surface
Protective Grille
Black Powder-coated hex-stamped perforated steel with acoustically transparent black fabric
Fitting
One / side rigid metal handle.
Dimensions (HxWxD)
825mm x 348mm x 423,3mm (32.48” x 17.71” x 16.67”)
Weight
31,5 Kg. (69.44 lbs)
