12
Introduction
w w w . t e c n a r e . c o m
T SERIES | rev.:1.1
TANIT
1.4.2.
TANIT SUB
TANIT SUB uses Neutrik® SpeakON® connectors. There are two NLT4 connectors on the rear of each TA
NIT SUB. These connectors made with Neutrik® NL-4 or NL-4 compatible in-line cable connectors.
All four pins of both connectors are wired in parallel to link multiple loudspeakers on a single amplifier
output. However, note that all four pins on each connector — even that are unused by the speaker itself-
wire in parallel (pin-to-pin) to all the other connectors on the cabinet. Remember that parallel connection
reduces the total impedance (Ω) seen by the amplifier.
Serial No.
Designed by
Made in Spain
C/ Encinar, 282 P.I. Monte Boyal
45950 - Casarrubios del Monte
(Toledo) TEL +34 91 8170110
EXEL ACOUSTICS SL -
www.tecnare.com e-mail: [email protected]
a c o u s t i c s
Read manual and safety instructions before use.
We recommend operate only with Tecnare T Series Amplifier
Bi-Amp:
Passive:
POWER LF
1800W AES
Bi-Amp
Passive
INPUT
LINK
IN SpeakON port
1+
1-
2+
2-
BI-AMP
(Autoconnect)
MF/HF+ MF/HF- LF +
LF -
PASSIVE
FR +
FR -
NA
NA
Fig. 3: TANIT SUB Connector Panel
Fig. 4: TANIT SUB Connector & diagram wiring
Fig. 5: TANIT System Passive
Mode. Connector & diagram wiring
Table 2: TANIT Connectors wiring
