11
Introduction
w w w . t e c n a r e . c o m
T Series | rev.:1.1
TANIT
1.4. Connections
TANIT
loudspeaker offers multiple ways to connect it. Use one type of connection at time.
Use the speakON
®
connector to connect one TANIT, or linked TANIT couple with a speakON
®
cable when it
is used in Standalone.
1.4.1.
TANIT
TANIT uses Neutrik
®
SpeakON
®
connectors. There are two NLT4 connectors on the rear of each TANIT.
These connectors made with Neutrik
®
NL-4 or NL-4 compatible in-line cable connectors. All four pins of both
connectors are wired in parallel to link multiple loudspeakers on a single amplifier output. However, note that
all four pins on each connector – even that are unused by the speaker itself are wired in parallel (pin-to-pin)
to all the other connectors on the cabinet. Remember that parallel connection reduces the total impedance
(Ω) seen by the amplifier.
The following subsections describe the electrical connections:
CAUTION:
The total impedance of the loudspeaker connected in parallel must not drop
below the minimum operating impedance of the amplifier. This will result in unsatisfac
-
tory performance and may cause damage to the amplifier.
SPEAKON:
1+= IN +
1- = IN -
2+= Link +
2- = Link -
Znom.
= 6 ?
POWER
:
1040W AES
PARALLEL
C/ Encinar, 282 P.I. Monte Boyal
45950 - Casarrubios del Monte (Toledo) TEL +34 91 8170110
Designed by
EXEL ACOUSTICS SL -
Made in Spain
www.tecnare.com e-mail: [email protected]
Serial No.
Read manual and safety instructions before use.
We recommend operate only with Tecnare T Series Amplifier
IN SpeakON port
1+
1-
2+
2-
Connection
1+
1-
NA
NA
Fig. 1: TANIT Connector Panel
Table 1: TANIT Connectors wiring
Fig. 2: TANIT Connector & diagram wiring
