142
CustomizingB3-SW&HW
i
nstalling
a
disk
This instruction applies to users who wish to exchange their disk.
B3’s interior is subject to ESD (Electro-Static Discharge) damage, and appropri-
ate measures must be taken to prevent damage. Always make sure that you
are electrically discharged before touching the B3’s circuit board or internal
connectors. To get electrically discharged touch something in your home that
is grounded, like an element, a sink or a water pipe.
1. Unscrew the three screws at the back of B3 using a Torx T10 (on older B3 use
2.0 hex) screwdriver. Remove the back panel and pull out the circuit board.
2. Cut loose two small pieces (10mm long) of heat pad and place on top of
each other. Then place them on the front of the hard drive (the side facing
from the hard drive connectors).
3. Looking into B3, attach one heat pad on the left hand side shown in picture.
Содержание B3
