Page | 7
OPERATING THE HEATER
WARNING!
Slight crackles may be heard during the heating or cooling period.
This is normal operational noise.
NOTE:
After switching on the appliance for the first time and following extended
periods on non-use, the appliance may expel a slight odour for a short time. It
will not affect the use of the heater.
To exclude unpleasant burnt odour, it is recommended to keep the heater
clean preventing accumulation of dust on it
The distance between the heater and the remote control should be less than
3 metres
, and the remote control must be directly pointed at the receiver on
the front panel during the operation.
Connect the unit to the main power, press the switch to the position of I : ON, the
red operation indicator will light to indicate the heater is on and the heater will
begin to radiate infrared heat.
OPERATION INSTRUCTIONS
：
1.
Plug in the device, and then press the switch to the positon of I (refer to picture
1). The device will sound 1beep, one of the heat lamp indicators will flash
(picture 1), the device is in standby mode and the unit won’t
radiate any heat.
