Excel 2-Bag Catcher 42", Руководство оператора

Страница: 13 / 40

119649 3-5 REV A
14. Attach the support gussets to the mower frame. The slots
in the support gussets must align with the keyhole slots in
the fender support bracket. Assemble the hardware as
shown with the cap screw inserted from the bottom.
Figure 3-4 View A
IMPORTANT: Be sure not to cut or pinch the fuel line
when installing gussets.
15. Thread a .375-16 nylon locking nut onto each of the tie
rods to the dimension shown in Figure 3-4 & Figure 3-8
16. Insert one tie rod through the key hole slot in the fender
support bracket and into the slot in the support gusset.
Make sure the nut on the tie rod is inserted through the
slot in the support gusset. Figure 3-4 & Figure 3-9
The nut end of the tie rod can be easily inserted through
the upper end of the slot if positioned horizontally then
angled upwards after the nut clears the support gusset.
Figure 3-4 & Figure 3-9
IMPORTANT: Be certain that the nut does not catch or
pinch the vapor line.
Then, insert the tie rod through the proper hole in the
catcher frame and secure with a hair pin. Figure 3-4
Repeat for the other side.
17. Push down on the catcher frame and tighten the lower
frame bolts. Pushing down on the catcher frame while
tightening these bolts will provide the correct tension on
the tie rods. Figure 3-10
18. Secure the vapor lines using the zip ties as shown. You
must secure the vapor lines to prevent them from rubbing
on the tie rods. Remove the excess zip tie. Figure 3-11 &
Figure 3-12
IMPORTANT:
Make sure the vapor line does not
become pinched and retains its original routing as it
comes out of the top of the fuel tank. Figure 3-13
Figure 3-6
Figure 3-8
Remove these bolts
Remove
this bolt
Fender
Fender
1” ± 1/16”
(19mm)
Tie rod
Nut .375-16 NYLK
Figure 3-7
Tether
Fuel cap
Fill neck
Tether
Fuel cap
Plastic cap
Fuel tank
Fender
Plastic cap