Excel 2-Bag Catcher 42", Руководство оператора, Страница: 14 / 40

REV A 3-6 119649
19. Re-attach the fenders to the mower frame. Do not
overtighten the mounting hardware. Figure 3-6
20. Remove the plastic cap from the fill neck opening and
screw the fuel cap onto the fill neck. Figure 3-7
21. Use a hammer and screwdriver to bend the tabs on the
deck inward enough to allow the steel hooks of the elastic
latch on the outlet tube to be inserted into the slot. Figure
3-14, Figure 3-15 & Figure 3-16
42” deck – There are two tab locations.
52” deck – There is one tab located at the rear side of the
deck.
22. Raise the deck discharge chute to the full up position
(90
o ) and slide the outlet tube into position.
It will be necessary to force the discharge chute to the 90
o
position. The chute will contact the mower fender before
the 90
o position is attained. Push on the discharge chute
until the chute is open enough to allow the tab of the
outlet tube to be inserted into the slot in the discharge
chute bracket of the deck. The downward spring force of
the discharge chute helps to secure the outlet tube to the
deck by locking the bump on the outlet tube with the
cams of the discharge chute. Figure 3-17 & Figure 3-18
Secure the outlet tube in place with the elastic latches.
Figure 3-14
23. Slide the end of the transfer tube into the opening in the
catcher lid. Figure 3-19
24. Attach the transfer tube to the outlet tube by aligning the
slot on the transfer tube with the knob on the outlet tube
and hooking the elastic latch through the loop of the
transfer tube. Figure 3-20 & Figure 3-21
25. Place the bags on the catcher frame by inserting the bag
frame hook into the catcher frame slot. Figure 3-22
26. Attach the catcher lid to the catcher frame using the CE
.375 x 3.00 with bale pins. Close the catcher lid. Figure 3-
23
NOTE: It is easier for two people to attach the catcher
lid to the catcher frame than it is for one person.
Figure 3-9
WARNING
Never operate the mower without the fuel cap threaded
tightly onto the fill neck.
Insert the tie rod through the keyhole as shown.
Tie rod
Support gusset
Then, angle the tie rod to secure the
nut against the support gussets.
Keyhole
Mower
frame
Nut
Tie rod
Figure 3-10
Tighten frame bolts
Push the catcher
frame down here