6 Pin Main Wire Harness (cont’d)
ORANGE WIRE - ACCESSORY (+) OUTPUT
This circuit is designed to drive accessory circuits like climate control, etc�� It
turns on when remote start is activated (slightly earlier than the primary ignition out-
put) and turns off only during engine cranking� It will turn back on for the remainder
of the remote start sequence.
CONNECTION:
An accessory circuit is typically found at the ignition switch� The
proper circuit will show +12v when the ignition key is in the ON/RUN position but not
in the START position�
VIOLET WIRE - START (+) OUTPUT
PINK/WHITE WIRE - IGN#2/PROGRAMMABLE (+) OUTPUT
This output is programmable to act as an additional ignition, accessory, or start
output. It supplies positive voltage for powering any additional circuits required
for remote starting the vehicle� The default operation is as an ignition circuit� See
installer feature #2 for the settings that change this operation�
CONNECTION:
The proper circuit will show +12v only when the ignition key is in the
position of the desired function� See the PINK, ORANGE, or VIOLET wire descrip-
tion for detail on your desired operation�
14 Pin Secondary Wire Harness
BLACK WIRE - SYSTEM GROUND (-) INPUT
REQUIRED�
This input provides negative ground for all system operations�
CONNECTION:
Using a properly sized ring terminal, connect this wire to the ve-
hicle’s chassis� Using an existing bolt is preferred but make sure that the connection
point is clean and free of dirt, grease, or paint� Bright shiny metal at the connection
point is desired�
ORANGE WIRE - STATUS/ANTI-GRIND (-) OUTPUT
BROWN/RED WIRE - BRAKE PEDAL (+) INPUT
REQUIRED�
This input is a critical safety circuit which disables the remote start
operation whenever the brake pedal is pressed�
CONNECTION:
Connect this to the brake switch wire that shows +12 volts when the
brake pedal is pressed�
ONLY AVAILABLE ON EDP+ MODELS -
This provides 500mA negative ground
while the alarm is armed and/or during remote start for anti-grind operation� The
operation is selectable with installer feature #16�
CONNECTION:
This wire is connected to the orange input wire on an optional start
interrupt relay�
REQUIRED�
This output supplies positive voltage to the vehicle’s starter circuit� If
using an anti-grind relay, connected this on the starter side of the relay�
CONNECTION:
The starter circuit is typically found at the ignition switch� The proper
circuit will show +12v only when the ignition key is in the START position�
MANUAL TRANSMISSION:
It is usually necessary to bypass the clutch switch dur-
ing remote start operations� Study the vehicle’s schematics for the best approach�
4
