The Status Light
VALET MODE
Valet mode completely disables all security & remote start functions Keyless entry is
still operable To enter valet mode, perform the following steps:
STEP 1 -
Disarm the system by remote or by performing an emergency override
STEP 2 -
Press and hold the valet switch for 2 seconds The system will chirp once
and the status light will turn on
EXITING VALET MODE
- Press and release the valet switch once
The status light, located in the antenna, indicates the system’s current status
SECURITY SYSTEM STATUS
OFF:
The alarm is disarmed and not performing any automatic functions
ON:
The alarm is in valet mode
FLASHING SLOW:
The alarm is armed and monitoring all entry points
FLASHING FAST:
One of the automatic arming features is in progress
AUTOMATIC TRANSMITTER VERIFICATION
Every time you turn on the ignition key, the status light will flash a number of times
equal to the number of controllers programmed to the system This unique security
feature combats potential thieves (valet attendant, mechanic, etc) from adding their own
transmitter without your knowledge and accessing your vehicle at a later time
ALARM ZONE VIOLATION RECALL
If the security system is triggered, upon disarming, the status light will flash
a number of times to indicate exactly which zone(s), has been violated It will
store the last 2 violated circuits and continually repeat the flash pattern until the vehicle’s
ignition key is turned ON
2 FLASHES:
Hood trigger
3 FLASHES:
Door trigger
4 FLASHES:
Sensor port trigger
REMOTE START STATUS
FLASHING SLOW:
The engine was remote started successfully and is running
FLASHING FAST:
The remote start sequence has begun and is in process of starting
2 FLASHES, PAUSE:
The engine is running while the alarm is armed
REMOTE START DIAGNOSTICS
The remote start system can also indicate which zone caused the last remote start
cycle to end To see this indicator, place the system into alarm valet mode Immediately
after the chirp, the status light will flash to indicate which zone violation occured.
1 FLASH:
The hood was opened
2 FLASHES:
Brake pedal was pressed or
3 FLASHES:
Bad tach signal or engine overrev
4 FLASHES:
The neutral safety circuit was triggered
5 FLASHES:
The 3D sensor detected vehicle motion
6 FLASHES:
Received command to stop
7 FLASHES:
The alarm was triggered
8 FLASHES:
Run time expired
9 FLASHES:
Low battery voltage was detected
Using The Valet Button (cont’d)
11
Содержание AL-1775-3DB
Страница 14: ...BLANK PAGE 13...
Страница 25: ...Back Cover Color cover is in a separate file 24...
