TuRBO TimER FEATuRE
PiT-STOP FEATuRE
This feature allows you to leave your engine running for making quick errands. To use this fea
-
ture, have the engine running normally from the ignition switch and your foot off the brake pedal�
Press the Valet Switch twice; the parking lights will flash and the horn chirps 5 times. Turn the key
off and the engine will remain running for the programmed run time�
mAnuAL TRAnSmiSSiOn STARTinG
Remote starting with a manual transmission requires a different installation method and
installer feature #11 must be turned on� Also, a setup procedure that ensures the transmission
was left in neutral must be performed each time you leave your vehicle and intend to use remote
start later� Perform these steps:
1) With the car running, hold the brake pedal, apply the parking brake, release the brake pedal�
2) Use the transmitter as if you were activating remote start (default: press START twice)� The
status light will start to flash slow.
3) Turn off the ignition key and exit the vehicle�
4) Press LOCK on the transmitter� The engine will shut down (unless turbo timer is on) and the
status light will flash every 2 seconds to indicate it is ready to be remote started.
nOTE: manual transmission setup will cancel if you enter the vehicle.
Other Remote Start Features (cont’d)
This is recommended for vehicles equipped with a turbocharger. It allows the engine to idle
after driving to cool the turbo� When this Installer Programmable Feature (#10) is enabled, the
system will automatically keep the engine running as follows:
• With the engine running, hold the brake pedal and engage the parking brake.
When the brake pedal is released, the system will keep the engine running for the programmed
time (1, 2, or 3 minutes), and then automatically turn it off�
• The system may be locked while the engine is running. Turbo Timer can be prevented from
engaging, or “bypassed” if desired, by turning the engine off before engaging the parking brake�
Security System Features
LAST DOOR ARminG
This system can be configured to arm automatically when all the vehicle’s doors are closed
(see user feature #9)� When enabled, the siren/horn will chirp once when all of the doors are
closed. It will start a 30 second countdown (indicated by a fast flashing status light) after which,
the system will lock and/or arm� The 30 second arming delay will paused while a point of entry is
open. Turning ON the ignition key will cancel the arming sequence until the key is turned off and
the doors are all closed once again�
NOTE: Installer feature #13 must be on and the system must be wired for security functions
AuTOmATiC REARminG
This automatically rearms the alarm if the system is disarmed from the remote� (see user
feature #10)� When disarmed by remote, the system will start a 90 second countdown (fast
flashing status light) to arm the system. This is useful if the controller accidentally disarms the
system when it’s kept in a purse or pocket where other items could potentially press the buttons�
ENHANCED AUTO REARM allows you to cancel the countdown by pressing UNLOCK a second
time within 5 seconds of the first press to disarm the alarm.
NOTE: Installer feature #13 must be on and the system must be wired for
security functions
method 2 - With The Controller (Low Volt + Low Temp - 15 Degrees Only)
• Within 5 seconds of pressing LOCK, press the START button. You will get one chirp to confirm.
nOTE:
When low temp start mode is activated, low voltage start is also activated� These features
will operate once every two hours until the ignition key is turned “ON”�
NOTE: Security features are optional for the RS-360-EDPB. Talk to your dealer to learn
more about upgrading.
7
