tape
4. Connect the wiper to the ship’s electrical installation; see the drawing above
(and the colour codes at page 19). Use a cable with 5 wires with a diameter
of at least 1½ mm
2
(16 g) up to a maximum length of 10 m. Use larger
diameters when using longer cables.
5. Fit a slow blow fuse of 8A (12Volt) or 6A (24 Volt) in the main cable.
6. Connect the switch to the wiper (refer to the switch manual for installation).
3.4 Final installation
7. Switch on the power and test the motor briefly. Wait until the motor stops
after turning off the switch. The motor will be in park position. The
standard park position is shown in the figure
under point 8.
Hint!
If you have doubts regarding the park position,
make a vane with tape to simulate the position of
the arms.
Attention!
The 255BS is suitable for wiper arms model P10 up
to 1000 mm and wiper-blades up to 1200 mm.
8. Place the wiper arm with the blade on the shafts. Fasten the nuts loosely
onto the shafts.
9
!
!