Manual FRAME-EVO-P10 / P10-US
Page
6
of
39
08.09.2021
Do not hang the frame from unstable or inappropriate structures.
•
If the frame is hung on an unstable structure, the entire system can fall down and
injuries may occur. Make sure that the construction can support a total weight of 175
kg (385.81 lbs) plus the weight of all additional equipment as well as other potential
systems.
Make sure to not exceed max. weight loads for ceiling mounting.
•
For suspended installations, use only designated hanging accessories, like EVO-LINK-
200 series, FRAME-PF-UNI-PORAD Portrait Adapter and FRAME-PF-UNI-CLP5030,
FRAME-PF-UNI-CLP30PT rigging clamps for a max. weight load of 175 kg (385.81 lbs).
Please refer to the corresponding instructions for the accessories used. Please also
refer to chapter “
11. Maximum stacking information
.
For stacking, make sure that all four locking pins pass completely through the female
stacking bolt.
•
Make sure the four male bolts enter into the correspondent female bolts and are
locked.
Do not install the FRAME-EVO-P10 / P10-US or the projector while people are present
under the mounting zone during the installation process.
•
When installing the projector, make sure no one is in the area underneath the
installation zone.
Always secure the frame to the rigging truss with rigging slings with steel cable insert and
shackles (two sets of rigging sling and shackle are recommended).
•
The frame must always be secured with an appropriate rigging sling and shackle so
that in case of a malfunc
tion it doesn’t fall more than 10
cm. It is recommended to
use two sets of rigging sling and shackle to avoid too much dynamic forces as well as
the projector swinging. Please consult the local laws or regulations regarding the
additional safety of hanging equipment.
CAUTION
Before installing the projector in the FRAME-EVO-P10 / P10-US frame, please read the
projector’s user manual. When the project
or has a lens attached, please remove it.
•
The FRAME-EVO-P10 / P10-US frame with the projector inside must be installed only
in an environment that is recommended by the projector manufacturer.
Minimum two persons are required to install the FRAME-EVO-P10 / P10-US frame.
