EWT Clima 1250 WK, Инструкция по установке и эксплуатации

Страница: 7 / 32

Operation - see Fig. 4
The neon switch marked (see ‘a’ in Fig. 4) controls the electricity
supply to the heating elements. The neon indicator light shows when
the appliance is actually heating. The switch marked - (half heat
– full heat) provides a choice of output as desired (see ‘b’ in Fig.4).
The heater is fitted with an adjustable thermostat enabling the room
temperature to be controlled by adjusting the setting accordingly.
Thermostat - see ‘c’ in Fig.4
The thermostat has a minimum setting represented by . Providing
the appliance has been switched ‘ON’ the heater will come on when
the surrounding temperature falls to approximately 6
o
C. This setting
may be used for protection against frost.
Switch on the heater and turn the thermostat knob to Max. and the heat
selector switch to full heat, to warm the room rapidly.
When the room temperature has reached the desired level, turn the
thermostat knob back slowly until the thermostat just clicks off. The
heater will then maintain the room temperature at the chosen level,
provided that the correct size of heater has been selected for the room
to be heated.
Useful Hints
Should your heater fail to operate please ensure:
1.
The thermostat setting is higher than the room temperature
by turning the control knob to the maximum position.
2. The safety cut-out has not operated by following the
procedure as detailed in ‘Safety - Overheat protection’.
Safety - Overheat protection
For your safety this appliance is fitted with a thermal cut-out. In the
event that the product overheats for some reason, the cut-out prevents
excessive temperatures on the product by cutting the power to the
heater. Once the heater has cooled down, it will reset automatically,
it will continue to cycle on and off automatically until the reason for
overheating is removed.
Recycling
For electrical products sold within the European
Community.
At the end of the electrical products useful life it
should not be disposed of with household waste.
Please recycle where facilities exist. Check with
your Local Authority or retailer for recycling advice
in your country.
Cleaning
WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY
BEFORE CLEANING THE HEATER.
Before commencing cleaning,switch off the heater and allow it to cool.
Disconnect the electricity supply to the appliance.
The outside can be cleaned by wiping it over with a soft damp cloth and
then dried. Do not use abrasive cleaning powders or furniture polish,
as this can damage the surface finish.
To release heater from the wall bracket for cleaning or redecoration,
depress latch on both brackets and hinge forward.
After Sales Service
Should you require after sales service or should you need to
purchase any spares, please contact the retailer from whom the
appliance was purchased or contact the service number relevant to
your country on the warranty card.
Please do not return a faulty product to us in the first instance as
this may result in loss or damage and delay in providing you with a
satisfactory service. Please retain your receipt as proof of purchase.
GB
4