OS3030
Manual control
10
Starting the "rinse during pro-
duction" phase
If the "rinse during production" phase has been
programmed, it can be started if the system is
in the "production" phase.
Press the "OFF" and "HORN" buttons simulta-
neously.
The possible stages, 1-3, are displayed in se-
quence in the LCD, together with the time
lapse.
Stopping the "rinse during
production" phase
If the system is in the "rinse during production"
phase, it can be stopped by pressing the
"OFF" and "HORN" buttons simultaneously.
"Standby Stop" phase
If the "ON" button is pressed at the same time
as the mains switch is switched on, the system
switches to the "Standby Stop". You can only
exit this phase by switching the controller off
and on without pressing any of the buttons
simultaneously.
The following functions are possible in this
phase:
1. Programming the controller
2. Starting/stopping the maintenance phase
3. Starting/stopping the "rinse after production"
phase
4. INFO display
During programming, all of the inputs are de-
activated, and none of the outputs are acti-
vated.
Starting/stopping the
"maintenance" phase
Switch the system to the "STANDBY" phase or
to "Standby Stop".
Press the "maintenance" button
If no code number is defined during the basic
programming, the "STANDBY" LED pilot lamp
goes off after 5 seconds.
However, if a code number has been defined,
enter the 4-digit code first of all using the " "
and "#" buttons. Keep the "maintenance" but-
ton pressed during this sequence.
The maintenance procedure can be started
and stopped using the "ON" and "OFF" but-
tons. Once the maintenance time programmed
in maintenance steps 16.1 and 16.3 has
elapsed, the maintenance procedure ends
automatically.
You can switch the system back to the
"STANDBY" phase by pressing the "mainte-
nance" button again.
WARNING!
The
"MAINTENANCE" phase
should be switched on by a properly trained
operator.
Acknowledging the "ALARM"
If the "ALARM" pilot lamp comes on, press the
"bell" button. This will trigger off the following
reactions:
1. It cancels the alarm relay it the alarm relay
has been programmed for the current alarm in
programming steps 7.9-7.11.
2. It switches off the integrated acoustic signal
sensor if the acoustic signal sensor has been
programmed for the current alarm in program-
ming steps 8.1-8.3.
3. It cancels the pilot lamp and the fault alarm
in the LCD.
WARNING: In the event of fault alarms which
cause the system to cut out, the pilot lamp and
the LCD cannot be cancelled until the fault has
been
rectified.
OFF
#
ON
OFF
OFF
