Design and function
Machine configuration menu
98
099-005444-EW501
17.03.2015
1 Preparation
• Switch off the welding machine.
• Unscrew the gas nozzle from the welding torch.
• Trim the welding wire, so that it is flush with the contact tip.
• Retract the welding wire a little (approx. 50 mm) on the wire feeder. There should now be no more
welding wire in the contact tip.
2 Configuration
• Press the "Welding parameter" push-button while simultaneously switching on the welding machine.
Release the "Welding parameter" push-button ("Choke effect" push-button with drive 4X LP).
• The required parameter can now be selected using the 'Welding parameter setting' rotary knob.
Parameter rL1 must be adjusted for all machine combinations.
In case of welding systems with a second power circuit
– if two wire feeders are to be operated from a
single power source, for example
– a second adjustment with parameter rL2 must be performed.
3 Adjustment/measurement
• Applying slight pressure, put the welding torch in place with the contact tip on a clean, purged location
on the workpiece and then press the torch trigger for approx. 2 seconds. A short-circuit current will
flow briefly, which is used to determine and display the cable resistance. The value can be between
0
mΩ and 40 mΩ. The new value is immediately saved without requiring further confirmation. If no
value is shown in the right-hand display, then measurement failed. The measurement must be
repeated.
4 Restoring welding standby mode
• Switch off the welding machine.
• Screw the gas nozzle onto the welding torch.
• Switch on the welding machine
• Insert the welding wire.
5.18.3 Power-saving mode (Standby)
The power-saving function can be activated either by pressing the button for a longer time - See 4.4
Machine control
– Operating elements chapter or by setting a parameter in the configuration menu (time-
based power-saving mode).
When power-saving mode is activated, both machine displays show the horizontal digit in the
centre of the display only.
Pressing any operating element (e.g. tapping the torch trigger) deactivates power-saving mode and the
machine is ready for welding again.
Содержание Taurus 355 Synergic S HP MM TKW
Страница 18: ...Machine description quick overview Rear view 18 099 005444 EW501 17 03 2015 4 2 Rear view Figure 4 2...
Страница 113: ...Appendix A JOB List 099 005444 EW501 17 03 2015 113 11 Appendix A 11 1 JOB List Figure 11 1...
Страница 114: ...Appendix B Overview of EWM branches 114 099 005444 EW501 17 03 2015 12 Appendix B 12 1 Overview of EWM branches...
