Machine control
– Operating elements
Machine display
099-00T400-EW501
21.10.2016
13
3.2
Machine display
The following welding parameters can be displayed before (nominal values), during (actual values) or
after welding (hold values):
"left display"
Parameter
Before welding
(nominal values)
During welding
(actual values)
After welding
(hold values)
Welding current
Parameter times
Parameter currents
Frequency, balance
JOB number
"right display"
Welding power
Welding voltage
When the hold values are displayed after welding and the settings are then changed (e.g. welding
current), the display will switch to the relevant nominal values.
possible
not possible
The parameters that can be set in the function sequence of the machine control depend on the selected
welding task. This means that if for example you have not selected a pulse variant, then you cannot set
any pulse times in the function sequence.
3.2.1
Setting the welding current (absolute/percentage)
The welding current for the ignition, secondary, end and hot start current can be set as a percentage of
the main current AMP or as an absolute value. To select, use the parameter
<dg in the configuration
menu_ref_source_inline>Gerätekonfigurationsmenü</dg_ref_source_inline>.
> see 4.7 chapter
