EWM Pico 350 cel puls pws MMA, Руководство по эксплуатации

Страница: 47 / 53

Rectifying faults
Display machine control software version
099-002061-EW501
05.05.2020
47
• Document machine errors and inform service staff as necessary.
• If multiple errors occur, these are displayed in succession.
• Document machine errors and inform service staff as necessary.
• If multiple errors occur, these are displayed in succession.
Error message Possible cause Remedy
E 0 Start signal set in the event of
errors
Do not press the torch trigger or the foot-
operated remote control
E 4 Temperature error Allow the machine to cool down
E 5 Mains overvoltage Switch off the machine and check the mains vol-
tage
E 6 Mains undervoltage
E 7 Electronics error Switch the machine off and on again.
If the error persists, notify service department
E 9 Secondary overvoltage
E12 Voltage reduction error (VRD)
E13 Electronics error
E14 Adjustment error in current record-
ing
Switch off the machine, place the electrode hol-
der in an insulated position and switch the ma-
chine back on. If the error persists, notify service
department
E15 Error in one of the electronics
supply voltages
Switch the machine off and on again.
If the error persists, notify service department
E23 Temperature error Allow the machine to cool down
E32 Electronics error Switch the machine off and on again.
If the error persists, notify service department
E33 Adjustment error in voltage record-
ing
Switch off the machine, place the electrode hol-
der in an insulated position and switch the ma-
chine back on. If the error persists, notify service
department
E34 Electronics error Switch the machine off and on again.
If the error persists, notify service department
E37 Temperature error Allow the machine to cool down
E40 Motor fault Check wire feed mechanism,
switch the machine off and on again, inform the
service department if the fault persists.
E51 Earth fault (PE error) Connection between welding wire and machine
casing
E55 Failure of a mains phase Switch off the machine and check the mains vol-
tage
E58 Short circuit in welding circuit Switch off the machine and check welding current
leads for correct installation, e.g. by placing the
electrode holder in an insulated position; detach
current lead from degaussing.
7.3 Display machine control software version
The query of the software versions only serves to inform the authorised service staff. It is available in the
machine configuration menu
> see 5.10 chapter
.