Page 6 of 10
Manual temperature setting
The user can use [
▲
] and [
▼
] button to enter a manual temperature other than the above pre-programmed
temperature. When manual temperature is in use, the
‘
PRE-SET
’
icon change to
‘
MANUAL
’
.
RF loss link indication
The receiver unit normally works well in the 30 m / 98 ft. range (at sign) with the Transmitter unit. However, if the
receiver unit is taken outside the wireless reception range or there is severe external radio interference, the
receiver may not able to receive the temperature signal from the Wireless sensor probe. If this loss link
condition persists more than 3 minutes, the device will start to alert user by emitting a beep sound once for
every 2 seconds for a duration of 10 minutes, prompting the user to correct the loss link. To re-link, the user
should return the device close to the transmitter cradle.
Belt clip installation
Put the belt clip in the lower hole in the back of receiver according to step 1 in below picture, keep the belt clip
in horizontal position and push it upward to slide into the upper hole as shown in step 2. Turn the belt clip 90
degree clockwise to lock it in the vertical position as step 3.
Clip the belt clip to the belt in below picture. Use finger pull out the receiver and raise to horizontal position to
easy the user view from top.
