3722-IG-002 Installation and User Manual
February 6, 2019
15
Power Wires
connected to
Power Disconnect
Switch
Wiring for Power
1.
After installing conduit between the breaker panel and the EVSE, pull through the AC wiring. Be sure to use stranded
copper wires. Note: The Power Disconnect Switch and Ground Bar can accommodate wires from 4-10 AWG.
2.
Turn the Power Disconnect Switch to OFF. (Figure 9). To lock the disconnect, lift the small plastic latch on the left
side and apply a lock.
Figure 9
Figure 10
3.
Attach the AC wires to the Power Disconnect Switch on the EVSE (Figure
10). Torque to 26.5 lb. in.
4.
Attach the green ground wire from the breaker panel to the EVSE’s GFCI
ground bar (Figures 10 & 10A). Torque 10 AWG wires to 20 in-lb, 8 AWG
wires to 25 in-lb, and 6-4 AWG wires to 35 in-lb.
5.
If required, proceed to wiring for serial communication on the next page.
If you are using a Zigbee Mesh Network, turn the Power Disconnect
Switch to ON (Figure 9) and proceed to Replacing the Cover on Page 17.
Figure 10A
Dip Switches
Data Router
ZigBee Antenna
(Optional)
AC wires and serial
communication
cable
Remote RF
Receiver Antenna
(Optional)
Grounding Wire
connected to GFCI
Ground Bar
OFF Position
ON Position
Tag Lockout Latch
Data Router
Swing Plate
